CUSHIONING SEALS

CROSS
SECTION
CODE MATERIAL HARDNESS
Sh/A
PRESSURE
bar
TEMPERATURE
C
*
SPEED
m/s
E0AN NBR 88 <=12 -5 +80 <=1
E0AV FPM 80 <=12 -10 +150 <=1

* Upon request the same items can be supplied with a special compound withstanding low temperatures up to - 25 C.

INSTALLATION AND DUTY GUIDELINE

During installation be careful not to pinch either the outside diameter or the inside lips.
The various parts of the cylinder should not show burrs or foreign matters which could compromise the correct installation and working of the seals themselves. It is recommended to comply with pressure, temperature and speed stated in this guideline. 

Furthermore, we recommend to test the compatibility of our material with grease and lubricants currently in use by you prior to any serial application.

Back to previous page

NOTICE.
Performances of seals depend, besides raw material quality and production processes, on various duty conditions.
It is recommended to carry out tests in extreme conditions before placing items in normal use, since a concomitance of critical factors may compromise their correct working. ELTE snc will keep the right to modify or improve any product without notice.