PISTON SEALS
CROSS SECTION	CODE	MATERIAL	HARDNESS Sh/A	PRESSURE bar	TEMPERATURE °C *		SPEED m/s
	E001N	NBR	75	<= 10	-5	+80	<= 1
	E001V	FPM	75	<= 10	-10	+150	<= 1
	E001M	NBR	75	<= 10	-5	+80	<= 1
	E001M...V	FPM	75	<= 10	-10	+150	<= 1
	E005N	NBR	75	<= 10	-5	+80	<= 1
	E005V	FPM	75	<= 10	-10	+150	<= 1
	E05N	NBR	75	<= 10	-15	+80	<= 1
	E05V	FPM	80	<= 10	-10	+150	<= 1
	P0Z8N	NBR	80	<= 10	-5	+80	<= 1
	P0Z8V	FPM	80	<= 10	-10	+150	<= 1

* Upon request the same items can be supplied with a special compound withstanding low temperatures up to - 25 °C. 

INSTALLATION AND DUTY GUIDELINE.

During installation an initial lubrication with grease should take place so that a correct working of the seals can be assured. 
The various parts of the cylinder should not show burrs, scratches or foreign matters which could obstruct the movement and compromise the correct working of the seals themselves. It is recommended to comply with pressure, temperature and speed stated in this guideline. 
Furthermore, we recommend to test the compatibility of our material with grease and lubricants currently in use by you prior to any serial application.

Back to previous page.

NOTICE.
Performances of seals depend, besides raw material quality and production processes, on various duty conditions.
It is recommended to carry out tests in extreme conditions before placing items in normal use, since a concomitance of critical factors may compromise their correct working. ELTE snc will keep the right to modify or improve any product without notice.